Most domestic plastering is priced as a fixed job after the tradesperson visits your home to assess the walls. While a plastering cost per m2 or a daily rate is highly useful for comparing quotes and budgeting from a floor plan, these are guide figures rather than what you will see on a final bill. Price guides give different ranges per square metre and per day, and the tables below show them side by side rather than as one figure.
Price per square metre or price per day?
Some plasterers work out a quote from a day rate, estimating how many days a job will take and adding materials and waste removal. A price per square metre given over the phone is a rough idea, not a final offer.
A written quote is a fixed price you can rely on, so it is usually easier to budget with than a day rate. If you agree to pay by the day and the work is slow, or a problem turns up that takes time to fix, you could end up paying more than you budgeted.
Typical prices per square metre
Price guides show typical published prices for 2026 to help you check whether a square metre quote is reasonable.
|
Job type |
Price per square metre |
|---|---|
|
Skim over sound plaster or plasterboard |
£15 to £25, or £13 to £30 when skimming a whole room |
|
Full replaster |
£30 to £40 for a two-coat replaster, £25 to £45 on bare brick |
|
Board and skim |
£25 to £40 for dot-and-dab plasterboard plus skim, £30 to £50 for stud-wall boarding plus skim, £25 to £45 for re-plaster or board and skim |
|
Ceiling skim |
£20 to £35 |
These figures are typical published prices for 2026 and your local quotes will differ based on the state of your walls. Smaller rooms cost more per square metre to plaster than large open spaces. For example, a small wall area of 19 square metres runs at £20 to £26 per square metre, falling to £13 to £17 per square metre for a large wall area of 43 square metres. Ceilings are usually priced separately from walls because working overhead takes more time and physical effort.
Day rates by region
If you are hiring a plasterer for a specific block of time, day rates vary significantly depending on where you live. The table below shows typical day rates by region. Other published figures for London and the South East are higher, for example £250 to £350 or more in some and £250 to £450 in others.
|
Region or setup |
Typical day rate |
|---|---|
|
North of England and Wales |
£180 to £250 |
|
Midlands and South West |
£200 to £280 |
|
South East and London |
£220 to £350 |
|
Plasterer with a labourer |
£300 to £450 |
These figures are typical published prices for 2026. A day rate typically covers standard materials such as plaster, PVA and corner beads, but materials are sometimes included and sometimes separate, so ask which applies. London and the South East are roughly 20 to 30 per cent higher than the rest of the country. A plasterer working with a labourer costs more per day. If you only need someone for a very small patch repair taking a few hours, the typical hourly rate is £25 to £40.
Skim, replaster and board and skim compared
The price you pay depends entirely on the type of plastering required. A skim is a thin finishing coat just a few millimetres thick. This goes directly over sound plaster or plasterboard to create a smooth surface ready for decorating. It is the cheapest option per square metre.
A full replaster is much more disruptive. It means hacking off the old failed plaster back to bare brick or blockwork. The plasterer then applies a thick backing coat to level the wall before adding the final finish coat. This requires more materials, creates heavy rubble and takes significantly more time.
Board and skim involves fixing new plasterboard to the walls or ceiling before applying the finishing coat. Dot and dab is a common method where plasterboard is stuck directly to masonry walls using dabs of strong adhesive. Overboarding is a technique used on ceilings where new plasterboard is fixed directly under an old, failing ceiling. This saves you from pulling the old ceiling down and dealing with extreme dust and disruption.
Older houses often have lath and plaster walls and ceilings. This is traditional lime plaster pushed onto narrow timber laths. Conservation bodies advise repairing original lime plaster where possible and replacing it like for like. Modern gypsum plaster or cement on old lime walls is a common cause of problems, because it can trap moisture.
Working out the area of your walls
To check a quote that is priced by the square metre you need to know the total area of your walls. You calculate this by measuring the length of each wall and multiplying it by the height. For example, a wall that is four metres long and two and a half metres high has an area of ten square metres. You then subtract the area of any large openings like doors and windows.
Once you have the total area for the room, you multiply it by the quoted rate range to get a rough check of the expected price. This simple arithmetic helps you spot if a quote is unusually high. Remember that a skim plastering or a full replaster will carry different rates, and ceilings must be calculated separately.
What pushes the price up
Preparation work is the main reason quotes differ. If the background is not prepared properly, the new coat can fail. Check whether your quote covers stripping old wallpaper, removing loose plaster and sealing painted surfaces, because some of this may be charged separately.
Dealing with textured coatings like Artex also increases the price. The Health and Safety Executive says textured coatings such as Artex may contain asbestos in any building built or refurbished before 2000. Work on them does not normally need a licensed contractor but must be done by people trained to work safely with asbestos. Homeowners should never sand, scrape or drill suspect coatings. You must tell tradespeople about these ceilings before work starts so they can take the right precautions.
Building regulations can apply to larger jobs. Where 25 per cent or more of an external wall is re-rendered, re-plastered or re-lined internally, the regulations normally apply. In these cases, the wall insulation would normally have to be improved at the same time to meet modern energy standards.
External render is priced per square metre, but scaffolding is often a separate line on the quote. External render comes as traditional sand and cement, lime, pebbledash, monocouche and modern thin-coat acrylic or silicone systems. K Rend is a manufacturer brand name that people often use loosely when talking about silicone render, but you should check exactly which system is being quoted.
When preparation is skipped or the wrong materials are used, the job will fail. These are the most common reasons a newly plastered wall goes wrong:
- Skimming over loose, damp or unsealed painted surfaces causes the new coat to crack or peel.
- Applying modern gypsum or cement on old lime walls can trap moisture and cause damp.
- Dry sanding or scraping Artex releases dangerous dust if the coating contains asbestos.
- Cash-only deals with nothing in writing leave you with no proof of what was agreed.
- Quotes that omit preparation, ceilings, scaffolding or waste lead to surprise bills on the final day.
Materials included or extra
A written quote must state clearly whether materials are included or charged as an extra. When skimming walls, the labour costs about £12 to £22 per square metre and the materials cost £3 to £7 per square metre. Gypsum finishing plaster costs £10 to £15 per 25kg bag, and one bag covers about 10 square metres of wall.
If a plasterer quotes a day rate, it typically covers standard materials such as plaster, PVA primer and metal corner beads. The total cost of materials per room usually ranges from £40 to £120. Always check whether VAT is included in the final price, because it would add 20 per cent if charged on top.
Waste removal is another extra cost. Waste disposal can cost £50 to £150 and may be charged separately. A trader who carries waste must be a registered waste carrier, and the register is public so you can check their credentials. You should also check that the cost of floor protection is included in the quote, as plastering is a messy trade and wet plaster can ruin carpets and floorboards.
Minimum charges and small jobs
Small jobs carry a minimum charge because of the fixed time it takes to travel, set up and clean down. A plasterer has to drive to your property, bring their tools inside, lay down floor protection, mix the plaster to the right consistency and wash all their buckets and trowels at the end of the day.
This setup and cleanup takes the same amount of time whether they are skimming a tiny patch or a whole room. Because of this routine, small jobs usually carry a minimum charge. Typical figures are £50 for small jobs plus materials, or around £120 to £150. This means a minor repair will cost more per square metre than a large extension.
How to check a quote and the final finish
A good quote is detailed and provided in writing. You should avoid cash-only deals with nothing in writing, as these leave you with no proof of what was agreed. Citizens Advice suggests getting written quotes from at least three different traders. They advise that a quote is a fixed price, whereas an estimate is just a rough guess that can increase later.
You should get a contract in writing and you should not agree to a deposit of more than 25 per cent. Citizens Advice also recommends paying by debit or credit card if you can. Depending on how you hired the trader, you might be able to cancel within 14 days of agreeing a contract.
A professional written quote should clearly list:
- The exact rooms and walls included in the price.
- Whether ceilings are being skimmed or left alone.
- The preparation work required, such as stripping wallpaper or sealing paint.
- The cost of all materials, including plaster, primer and metal beads.
- The cost of waste removal and floor protection.
- Whether VAT is included in the final figure.
Under the Consumer Rights Act 2015, work must be done with reasonable care and skill. If the work is wavy, cracked or poorly finished, the customer can ask for it to be put right or seek a partial or full refund. Plastering is not a licensed trade and there is no legal register like the one for gas engineers, so evidence of past work matters. A CSCS card is meant for construction sites and is not proof of quality on domestic work. TrustMark is the government-endorsed quality scheme, and FIS is the trade body for the finishes and interiors sector.
Before paying the final balance, you need to check the finish. Plaster should be smooth to the touch with no deep trowel marks or scratches. The corners should be sharp and straight. Shine a light across the wall from the side, as this highlights any wavy finishes that you will see every day once the wall is painted. The plaster needs time to dry before you can decorate. Your plasterer can tell you how long to leave it.
Common questions
What is the cost of plaster per square metre?
Price guides give separate ranges by job type, as in the table above. For example, a skim over plasterboard is £15 to £25 per square metre. Materials alone are £3 to £7 per square metre for skimming walls, and a 25kg bag of gypsum finishing plaster at £10 to £15 covers about 10 square metres.
How much plastering can be done in a day?
Published figures put skimming at roughly 20 to 40 square metres of wall in a day. This depends heavily on the condition of the background, the layout of the room, and whether they are working alone or with a labourer.
Does rendering need planning permission?
In England, according to the Planning Portal, rendering needs no permission if the materials are of similar appearance to the existing house. It does require permission in conservation areas, National Parks, Areas of Outstanding Natural Beauty and the Broads. Listed buildings need consent for any significant work inside or out. Elsewhere in the UK, or if you are unsure, check with your council.
Can you plaster over painted walls?
You can often plaster over paint that is sound and firmly stuck, but wallpaper has to be stripped first. If a plasterer skims over loose, damp or unsealed painted surfaces, the new coat can crack or peel, so the plasterer will decide on site how to prepare the wall.
Next steps for your plastering job
Before you hire a plasterer, make sure you have the right details in place to protect yourself and your home.
- Measure your walls to work out the rough square metre area.
- Ask for three written quotes and check if they are fixed prices or just estimates.
- Check that preparation, waste removal, floor protection and VAT are listed on the quote.
- Do not pay a deposit of more than 25 per cent.
- Tell the tradesperson about any textured ceilings built before 2000 so they can manage the asbestos risk.
- Ask to see evidence of their past work, as plastering is not a licensed trade.
Getting a smooth finish requires skill and careful preparation. When you are ready to start gathering quotes, you can find a plasterer near you to look at your walls and provide a fixed price for the job.
Find a top rated plasterer near you
1,036 plasterers across the UK, each ranked on their Google rating and the number of reviews behind it. Start with your county: